Log

Just to print log for debugging

Print Log via Serial Port

Connection Diagram

Wire Connection Diagram

Black Wire to Black Wire

Procedure of Print Log

1. Download driver of CP2102 from the following link:

8MB

CP210x_Drivers.rar

Open

1. Install driver of CP2102 by double clicking the compressed file->CP2102_Drivers_Win10->double clik "CP210xVCPInstaller_x64.exe" to install directly

1. Go to Device Manager->Click Ports (COM & LPT)->Check Silicon Labs CP210x USB to UART Bridge (COM19)

1. Get encoder and Axis IP Camea (one by one)connected to the same router or switch and make sure they're on the same local area network;

2. Pull RTSP Stream of Axis IP Camera (one by one) into the encoder directly no matter whether it's successfully streaming in the encoder;

3. Download PuTTY from following link:

1MB

putty.exe

Open

1. Run PuTTY->Select "Serial"->Serial Line"COM19"->Speed "115200"

1. Select Logging->Printable Output->Click"Browse"->Rename the file of log->Save->Click "Open"->Then it'll start printing the log, when it always prints one same error like gpio_i2c_failed->Then click "EXIT" to save this log.

1. Once done, then power off all devices, connect another AXIS IP Camera and do it again.

Print Log via CGI

1. Get encoder and Axis IP Camea (one by one)connected to the same router or switch and make sure they're on the same local area network;

2. Specify the IP address (192.168.1.64 ONLY), username(admin) and password (12345) for the encoder via Device Manager;

3. Pull RTSP Stream of Axis IP Camera (one by one) into the encoder directly no matter whether it's successfully streaming in the encoder;

4. Run a browser like Chrome and enter the following CGI command in the browser's Address field: http://192.168.1.64/cgi/download?file=log&user=admin&pwd=12345, then save the log;

5. Then connect another AXIS IP Camera and do it again.