ROUTER V519
  • About EXVIST
  • 📌GETTING STARTED
    • Introduction
    • Interfaces
    • Quick Start
  • ✨Configuration
    • Dashboard
    • Resource
    • Interface
    • Network
      • LTE
      • LAN
      • AP Client
      • Routing Table
      • Source Routing Table
      • Port Map
      • Firewall
      • ALG
      • Hosts
    • Wireless
      • SSID
      • Channel
      • Advanced
      • ACL
    • Station Control
      • Station List
      • Station Address Bind
      • Station Wake Up
      • Internet Control
      • Station Internet Control
      • Access Control
      • Station Access Control
      • Traffic Reference
      • Station Traffic Control
      • Default Traffic Control
    • Application
      • DDNS
      • HA(VRRP)
      • OpenVPN Client
      • LTE GPS
      • Serial#1
      • JT808 GPS Report
      • UPNP
      • IGMP Proxy
      • Multicast Routing
      • L2TP Client
      • PPTP Client
      • GRE Tunnel
    • System
      • Device
      • Configure
      • Software
      • Password
      • Web Server
      • Telnet Server
      • SSH Server
      • Manage Server
      • Auto Reboot
      • LED/IO Control
    • Debug
      • Syslog
      • Terminal
      • LTE Adjust
      • Development
      • SDK
      • Crontab
      • Inittab
      • Uninittab
      • Jointtab
      • Service
      • COM Interface
  • 📤FIRMWARE
    • Download
  • 🎆RESOURCES
    • FAQ
    • Official Store
    • YouTube Channel
Powered by GitBook
On this page

Was this helpful?

  1. Configuration
  2. System

Auto Reboot

PreviousManage ServerNextLED/IO Control

Last updated 4 years ago

Was this helpful?

Auto Reboot

In this section, it allows the user to set reboot mode. The router will run slowly for a long time. To prevent router failure, it is recommended to set the router to automatically restart. The default factory setting is idle restart, and the user can set the restart mode according to actual usage. Please check below details:

✨