ROUTER V519
  • About EXVIST
  • 📌GETTING STARTED
    • Introduction
    • Interfaces
    • Quick Start
  • ✨Configuration
    • Dashboard
    • Resource
    • Interface
    • Network
      • LTE
      • LAN
      • AP Client
      • Routing Table
      • Source Routing Table
      • Port Map
      • Firewall
      • ALG
      • Hosts
    • Wireless
      • SSID
      • Channel
      • Advanced
      • ACL
    • Station Control
      • Station List
      • Station Address Bind
      • Station Wake Up
      • Internet Control
      • Station Internet Control
      • Access Control
      • Station Access Control
      • Traffic Reference
      • Station Traffic Control
      • Default Traffic Control
    • Application
      • DDNS
      • HA(VRRP)
      • OpenVPN Client
      • LTE GPS
      • Serial#1
      • JT808 GPS Report
      • UPNP
      • IGMP Proxy
      • Multicast Routing
      • L2TP Client
      • PPTP Client
      • GRE Tunnel
    • System
      • Device
      • Configure
      • Software
      • Password
      • Web Server
      • Telnet Server
      • SSH Server
      • Manage Server
      • Auto Reboot
      • LED/IO Control
    • Debug
      • Syslog
      • Terminal
      • LTE Adjust
      • Development
      • SDK
      • Crontab
      • Inittab
      • Uninittab
      • Jointtab
      • Service
      • COM Interface
  • 📤FIRMWARE
    • Download
  • 🎆RESOURCES
    • FAQ
    • Official Store
    • YouTube Channel
Powered by GitBook
On this page

Was this helpful?

  1. Configuration
  2. Debug

Uninittab

PreviousInittabNextJointtab

Last updated 4 years ago

Was this helpful?

Uninittab

In this section, it allows the user to configure close port when powering off the router, but it's not recommended to do that because it's for debugging only. Please check below details:

✨