1080P Extender
  • About EXVIST
  • 📌GETTING STARTED
    • Introduction
    • Quick Start
  • 🛠️Configuration
    • Specification
    • Interfaces
    • Package
    • RTSP
  • 📤Upgrade
    • Download Firmware
    • Upgrade Firmware
  • 🎆RESOURCES
    • FAQ
      • Troubleshooting & Solutions
      • Compatibility
      • Abnormal Image
      • Transmission Mode
      • Output Resolution of RX
      • WiFi Channel of TX
    • Official Store
    • YouTube Channel
Powered by GitBook
On this page
  1. RESOURCES
  2. FAQ

Transmission Mode

PreviousAbnormal ImageNextOutput Resolution of RX

Last updated 1 year ago

Why is there image lagged or offline when transmitting the video from 1x transmitter to 5x receivers?

In this case, it's strongly recommended to enable Multicast for both transmitter and receiver. Please follow below steps:

  1. Connect the transmitter and receiver to your PC via Ethernet cable directly;

  2. Respectively access the transmitter and receiver from browser (default IP: 192.168.1.166 for Transmitter, 192.168.1.167 for Receiver)

  3. Go to System config->Multicast config->Check the checkbox of Enable->Click "SET UP"(please make sure it's all set successfully for both transmitter and receiver;

  4. Then check whether it works properly.

🎆